Husqvarna CL400 Manual De Uso Y Mantenimiento página 17

•
Pull the motor's starter handle (fig.1 no.2) with force. Before using the machine, wait for a few minutes in order
to allow the motor to reach its proper operating temperature.
•
Be sure to also follow the instructions described within the motor's manual.
Before initiating any work activities
•
Position the cable upon the spool, adjust the machine's cable laying depth and tie the loose end of the cable to
a peg.
•
Make sure that there are no people, animals or foreign objects within 15 metres of the machine.
•
Start the motor and wait for it to reach its proper operating temperature before beginning.
•
Bring the cutter activation lever (fig.1 no.9) and the advancement activation lever (fig.1 no.1) to their working
positions and begin working. Use maximum caution while operating the machine.
•
Be sure to carefully read the operation descriptions provided below.
•
During the summer, or whenever operating upon dry terrain, it is recommended to water the operating area
abundantly the day before the work is to be performed.
THE MACHINE MUST BE SUBJECTED TO A TRAIL STAGE! THE BELTS WILL ADJUST DURING THE FIRST HOUR OF WORK.
MAKE SURE THAT THE TENSION ADJUSTMENT SPRINGS ARE ALWAYS WORKING PROPERLY (fig.1 no.4/no.5).
Cable guide installation or replacement
The cable guide is made up of several parts that must be assembled prior to attaching the guide to the machine. The
assembly outline is shown in Fig. 3.
In the cable guide structure (E) insert in the following order:
1. O-ring (D)
2. Spacer (C)
3. Lock nut (B)
With the nut slightly loose, insert the tube (A) until it exits at the bottom part for about 5 mm. At this point, the nut is
tightened with an. 17 wrench and consequently the tube is locked. In Fig. 4 you can see the cable guide properly,
assembled.You can then proceed to secure the cable guide to the machine structure.
Fig. 3 Fig. 4
17
English