Assembly And Operation - Worx WX543 Manual De Instrucciones

of workpiece is processed dependant on the
following examples and other variations on how the
tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing
the job. This may significantly reduce the exposure
level over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for sawing wood, plastic,
metal and building materials while resting firmly on
the workpiece. It is suitable for straight and curved
cuts. The saw blade recommendations are to be
observed.

ASSEMBLY AND OPERATION

ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery
Installing the battery pack
Cordless Jigsaw
ASSEMBLY
Blade Installation
NOTE: Ensure the blade is installed
in place. The black line on the blade
needs to be totally inserted into the
tool-free blade holder.
Blade Removal
NOTE: Hold the blade with one
hand when remove the blade.
Vacuum Adapter Installation
OPERATION
Pendulum Function
Safety On/Off Switch
NOTE: For safety reasons the On/
Off switch of the machine cannot
be locked; it must remain pressed
during the entire operation.
Increasing or reducing the pressure
on the On/Off switch enables
stepless stroke-rate control of the
switched-on machine.
Straight Cut and Curve Cut
Bevel Cut
NOTE: Remove the vacuum adapter
before adjust the base plate.
NOTE: Rotate the base plate to the
desired position according to the
scale. Ensure the blade is engaged
between the blade positioning
wheel .
Plunge Cut
WORKING HINTS FOR YOUR
JIGSAW
If your power tool becomes too hot, please run your
jigsaw no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds.
Always use a blade suited to the material and
material thickness to be cut. For tight curves it is best
to use a narrow saw blade. When sawing metal or
similar materials, apply coolant/lubricant alongside
FIGURE
the cutting line.
Always ensure the workpiece is firmly held or
clamped to prevent movement. Any movement of
the material may affect the quality of the cut. The
blade cuts on the upward stroke and may chip the
See Fig. A1
uppermost. Ensure your uppermost surface is a non-
See Fig. A2
visible surface when your work is finished.
For easier control, use low speed to start cutting and
See Fig. A3
then increase to correct speed.
See Fig. B1
See Fig. B2
See Fig. B3
See Fig. C
See Fig. D
See Fig.
E1, E2
11
See Fig.
F , G
See Fig. H
EN