Assembly And Operation - Worx BladeRunner X2 WX572L Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
BladeRunner
®
table-top tool for cutting wood, metal, plastic,
and ceramic tile. Lightweight and portable for
use right at the work area. Blade is stationary
while user moves the material for easier, more
precise work.
BEFORE PUTTING THE MACHINE INTO
OPERATION
1. All covers and safety devices have to
be properly fitted before the machine is
switched on.
2. The blade must run freely.
3. When working with wood that has been
processed before, watch out for foreign
bodies such as nails or screws etc.
4. Before turning on the machine, make
sure that the saw blade is correctly fitted
and that the machine's moving parts run
smoothly.
5. If the cutting operation will produce a
high amount of dust, especially hazardous
14
dust such as ceramic tile or treated wood,
connect an effective vacuum to the vacuum
port (8)

ASSEMBLY AND OPERATION

Action
Guard Arm Installation
Blade Installation
Blade Changing
Stabilizer bracket
Adjustment
Guard Adjustment
ON/OFF Safety Switch
Rip Cut
Cross Cut
Miter Cut
Internal Cut
Dust Collection
Store the Accessories
BladeRunner
X2— A compact, easy-to-use
Figure
See Fig. A1,A2
See Fig. B1-B3
See Fig. C
See Fig. D1,D2
See Fig. E1,E2
See Fig. F
See Fig. G1-G3
See Fig. H1,H2
See Fig. I1,I2
See Fig. J
See Fig. K
See Fig. L1-L4
X2
®
MAINTENANCE
WARNING:
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
To insure proper operation and extend tool
life, prevent dust from accumulating under the
Table Insert (5).
a) Be sure to use a vacuum or dust extractor
for dusty cutting operations such as
ceramic tile. (See Fig. M)
b) If dust accumulates, remove the Table Insert
by lifting the latch (e). (See Fig. N)
c) Vacuum out the dust in and around the
Blade Holder. (See Fig. O)
d) Reattach the Table Insert securely.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of
dust. If you see some sparks flashing in the
ventilation slots, this is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido