Troubleshooting Guide - Oregon Scientific OUTBREAKER RX109 Serie Manual De Usuario

• Cleaning – Clean with a damp cloth. Do not use liquid
cleaning agents, benzene, thinner, or aerosols.
• Repair – Do not attempt to repair the product or modify the
circuitry by yourself. Contact the retailer or a qualified
repairman if the product requires servicing. Only use
replacement parts that are recommended by the
manufacturer.
• Do not scratch hard objects against the LCD display as this
may cause damage.

TROUBLESHOOTING GUIDE

This section includes a list of frequently asked questions for
problems you may encounter with the OUTBREAKER sports
watch. If your watch is not operating as you think it should,
check here before arranging for servicing.
Problem Symptom
No power Power will not turn
on.
Keys do not respond
Date / time Date display is
is wrong wrong
RX109-English.P65
All manuals and user guides at all-guides.com
Check this Remedy
Batteries are Replace with new
exhausted. batteries.
Batteries are inserted Insert the batteries
incorrectly. correctly ( 7).
Key lock in Press key/lock for 2
operation. seconds (Key icon will
(Key icon shown) disappear).
Date not set Set date correctly ( 9)
Cannot be changed when
TOUR Mode is operating.
26
Problem Symptom
Time display is
wrong
Altitude Reading is less than
reading is 0 (-20, etc.)
strange
Different height
reading at same
point after trip
No altitude Alarm does not
alarm sound
Temperature Too high
reading is
strange
No weather Weather icon
reading disappears
Wrong unit Incorrect unit setting
reading
(imperial/
metric)
No alarm Expected alarm
does not sound
Pressure Too high or low
reading is
strange
26
2004.9.2, 3:08 PM
Check this Remedy
Time zone set Reset time zone
incorrectly Cannot be changed when
TOUR Mode is operating.
Current altitude is Reset watch, or accept
below ground, (watch reading
sea level setting)
Barometric changes Minor pressure changes
may produce minimal
deviations in altitude
readings
Levels not set Set levels ( 12)
Watch is too close to Take off watch, wait 15
body minutes, then try again
Height displacement Remain at fixed altitude
(Vertical movement) for 5 minutes
Unit settings Set units ( 9)
Levels not set Set levels ( see relevant
MODE Section)
Alarm not activated Activate alarm ( see
relevant MODE section)
Is change due to Reset after you have
wind, pressurized changed locations
chamber, or
pressurized
environment
(airplane)?