Troubleshooting - Kobalt SGY-AIR86TZ Manual Del Usuario

TROUBLESHOOTING

If you have any questions regarding the product, please call customer service at
1-888-3KOBALT, 8:00 a.m.-8:00 p.m., EST, Monday-Friday.
PROBLEM
One side of nozzle is clogged.
a) Loose air nozzle.
b) Material around outside of air
nozzle has dried.
a) Atomization air pressure is set
too high.
b) Trying to spray a thin material
in too wide a pattern.
a) Packing around needle valve is
dried out.
b) Fluid nozzle loosely installed, or
dirt between nozzle and body.
c) Needle sealing damaged.
a) Gun improperly adjusted.
b) Dirty air cap.
c) Fluid tip obstructed.
d) Sluggish needle.
Fan adjustment screw not seating
properly.
SPRAY PATTERN/
CONDITION
Intermittent spray
Improper spray
pattern.
Unable to get
round spray.
11
SOLUTION
Soak nozzle in solvent to
loosen clog, then blow air
through until clean. To clean
orifices use a broom straw
or toothpick. Never try to
detach dried material with
sharp tool.
a) Trigger air nozzle.
b) Take off air nozzle and
wipe off fluid tip, using a
rag moistened with thinner.
a) Reduce air pressure.
b) Increase material control
by turning fluid adjustment
knob to left, while reducing
spray width by turning
spray pattern adjustment
knob to right.
a) Back up knurled nut, put a
few drops of machine oil
on packing, retighten nut.
b) Take off fluid nozzle, clean
rear of nozzle and seat in
gun body. Replace nozzle
and bring in tight to body.
c) Replace seal.
a) Re-adjust gun. Follow
instructions carefully.
b) Clean air cap.
c) Clean.
d) Lubricate.
Clean or replace.