Principle Of Operation - EdilKamin IDROFLEXA Instalación Uso Y Mantenimiento

featureS

principle of operation

L
The fuel (pellets) is transferred from the storage hopper (A)
to the combustion chamber (d) by means of a feed screw (b),
which is driven by a gear motor (c). The pellets are ignited by
the air that is heated by an electrical resistance (E) and drawn
into the combustion chamber by a centrifugal fan (M). The
fumes produced during the combustion process are extracted
from the hearth by the same centrifugal fan (M) and expelled
A
through the outlet (F) located on the lower part at the back of
the boiler-stove.
The ash falls into the pan (I) where it gathers for emptying.
IThe hearth is realised with an internal structure in aluminium/
b
cast iron and is closed frontally by two overlapping panes:
- external glass ceramic door
d
c
- an inner door made from ceramic glass which is in direct
E
contact with the fire.
I
The pellet hopper is at the top of the boiler-stove.The hopper is
filled through a lid found at the back of the top
The water in the boiler-stove is heated and sent to the heating
F
system by the pump built into the boiler-stove.
M
The boiler-stove has a built-in closed expansion tank and over-
pressure relief valve.
Fuel quantity, smoke extraction and combustion air supply
and pump operation are all controlled by an electronic control
board, which is equipped with galileo software to achieve
*
high combustion efficiency and low emissions.
The synoptic panel (L) is installed on the top, through which
all phases of operation can be displayed and controlled.
The main phases can be managed via the optionally supplied
remote control.
The external covering is available in the following colours and
materials:
- ceramic: opaque white - red and hazelnut
- plating: grey steel sides, grey ceramic top
*
GALILEO is a combustion safety and control system which al-
lows optimal performance in all conditions.
GALILEO guarantees optimal functions thanks to a sensor that
measures the air flow contributing to combustion.
The surveying and consequent optimisation of the combustion
parameters takes place in a continuous way, so as to correct any
possible functioning anomalies in real time
The GALILEO system offers constant combustion, automatical-
ly regulating the draft based on the characteristics
of the chimney flue (bends, length, shape, diameter, etc..) and
environmental conditions (wind, humidity, atmospheric
pressure, installations at high altitude, etc.). The standards for
installation must be respected.
- 5
-