Installing The Solid-State Drive (Full-Length) - Dell Precision 5510 Manual Del Usuario

3. Remove the screw that secures the solid-state drive to the system board.
4. Remove the thermal pad from the SSD.
NOTE: The thermal pad is applicable only for a PCIe SSD card.

Installing the Solid-State Drive (full-length)

1. Adhere the thermal pad to the solid-state drive.
NOTE: The thermal pad is applicable only for a PCIe SSD card.
2. Slide the solid-state drive at an angle into the solid-state drive slot.
3. Press the other end of the solid-state drive down and replace the screw that secures the solid-state drive to the system board.
4. Install the:
a) battery
b) base cover
5. Follow the procedures in After Working Inside Your Computer.
12 Extracción e instalación de componentes