Removing The Dc-In Connector; Installing The Dc-In Adapter Port; Removing The Antenna Cover - Dell Precision 5510 Manual Del Usuario

Ocultar thumbs Ver también para Precision 5510:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Replace the screws that secure the display hinges to the palm-rest assembly.
4. Adhere the tape and route the touch-screen cable through the routing guides on the fan.
5. Connect the touch-screen cable and display cable to the system board.
6. Replace the screw that secures the display-cable bracket to the system board.
7. Follow the procedures in After Working Inside Your Computer.

Removing the DC-in Connector

1. Follow the procedures in
2. Remove the:
a)
base cover
b)
battery
3. Perform the following steps to remove the I/O board:
a) Disconnect the DC-in cable from the system board [1].
b) Remove the screw that secures the DC-in cable to the computer.
c) Remove the DC-in connector from the computer.

Installing the DC-in Adapter Port

1. Place the DC-in adapter port into the slot on the palm-rest assembly.
2. Route the power-adapter port cable through its routing guides on the palm-rest assembly.
3. Replace the screw that secures the power-adapter port to the palm-rest assembly.
4. Connect the power-adapter port cable to the system board.
5. Install the:
a) battery
b) base cover
6. Follow the procedures in After Working Inside Your Computer.

Removing the antenna cover

1. Follow the procedures in
2. Remove the:
a)
base cover
b)
battery
c)
WLAN Card
24
Extracción e instalación de componentes
Before Working Inside Your
Before Working Inside Your
Computer.
Computer.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

P56f

Tabla de contenido