Removing The Memory Module(S); Installing The Memory Module(S); Removing The System Board - Dell Precision 5510 Manual Del Usuario

Removing the Memory Module(s)

1. Follow the procedures in
2. Remove the:
a) base cover
b) battery
3. Pry the securing clips away from the memory module until it pops-up. Remove the memory module from its connector on the system
board.

Installing the Memory Module(s)

1. Insert the memory module into the memory socket.
2. Press the memory module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and re-install it.
3. Install the:
a) battery
b) base cover
4. Follow the procedures in After Working Inside Your Computer.

Removing the System Board

1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a) base cover
b) battery
c) fans
d) heatsink
e) SSD
f) memory modules
NOTE: Your computer's Service Tag is located under the system badge flap. You must enter the Service Tag in the
BIOS after you replace the system board.
NOTE: Before disconnecting the cables from the system board, note the location of the connectors so that you can
re-connect them correctly after you replace the system board.
Before Working Inside Your Computer.
Extracción e instalación de componentes 17