American Standard Mainstream Manual Del Usuario página 7

1
INSTALLATION OF WALL POST
• In this step, you'll need following parts: [1] x4, [2] x4, [4] x4, [5] x4, [8] x1
• In this step, you'll need the following tools: A, B, F, J, K, N
NOTE: Please decide which way you want the door to swing open prior to installation. Installation shown is
with door handle on the right side. To reverse, simply rotate door 90 degrees so holes in door on are the left.
NOTE: Use a level to make sure your alcove is plumb and square prior to installation.
32" width=752-792
1a. Remove Wall Posts [8] from box and place 15 mm from outer edge of base (ref illustration). The flange
side of the wall post with holes drilled should face inside of shower. Ensure Wall Post [8] is plumb and
mark each of the pre-drilled holes.
1b. Remove Wall Post [8] and if using Wall Anchors [1] drill previously marked locations using a 6 mm drill bit.
If not using Wall Anchors, drill using appropriate size bit for screw being used.
1c. Insert Wall Anchors [1] into each drilled hole.
1d. Place Wall Post [8] back onto wall over previously drilled hole and screw Post into place using ST4x35 [2]
and Back Screw Caps [5] (ref. illustration).
1e. Place Screw Caps [4] over each Back Screw Cap [5] and snap into place.
[8]
1a
1b
[5]
6mm [2]
Screw
ST4x35
VIEW FROM INSIDE
1c
[1]
1d
1e
[4]