American Standard Mainstream Manual Del Usuario página 9

3
INSTALLATION OF OPPOSITE SIDE WALL POST
• In this step, you'll need following parts: [5] x2, [8] x1, [11] x1, [19] x1, [21] x1
• In this step, you'll need the following tools: B, J, K, F, N
NOTE: TWO PEOPLE REQUIRED
3a. Place opposite Wall Post [8] 15 mm from outer edge of base (ref illustration) as in step 1. Ensure Wall
Post is plumb and mark each of the pre-drilled holes.
3b. Remove Wall Post [8] and if using Wall Anchors [1] drill previously marked locations using a 6 mm drill bit.
If not using Wall Anchors, drill using appropriate size bit for screw being used.
3c. Insert Wall Anchors [1] into each drilled hole.
3d. Place Wall Post [8] back onto wall over previously drilled holes and screw Post into place using
ST4x35 [2] and Back Screw Caps [5]. (ref illustration)
3e. Place Screw Caps [4] over each Back Screw Cap [5] and snap into place.
A
3a 3c
[1]
N G
3b 3d
J
K
6mm
F
3e
VIEW FROM INSIDE
B
[5]
[2]
Screw
ST4x35
[4]