Fitting And Removing The Wheels - bebeduE NIK Manual Del Usuario

INSTRUCTIONS
1. ASSEMBLING THE PUSHCHAIR
1. 1. UNFOLDING
• Release the safety lock on the chassis (A) (fig. 1)
• Open up the chassis by pulling on both sides (fig. 2 & 3), until it is fully opened (fig. 4)
• Lift up the handlebar by pressing the two inside buttons at the same time (fig. 5). The
handlebar has two positions (fig. 6 & 7), which can be changed by pressing both side
buttons at once and moving it up or down at the same time.

1. 2. FITTING AND REMOVING THE WHEELS

• Fit the back wheels (B) by inserting their axle into the appropriate housings at the
sides, at the bottom on the back (fig. 8). Press each wheel until it clicks into place
and make sure it is properly secured by pulling it outwards. The back wheels can be
removed by pulling the spring under each wheel bracket outwards, and at the same
time pulling the wheel out of its housing (fig. 9)
• Fit the front wheels (C) by inserting their axles into the housings at the bottom on
the front (fig. 10). Press each wheel until it clicks into place and make sure it is properly
secured by pulling it outwards. The front wheels can be removed by pulling the spring
under each wheel bracket outwards, and at the same time pulling the wheel out of its
housing (fig. 11). The front wheels can be stopped from turning by pressing down the
white levers located over each wheel (fig. 10). Likewise, pull these levers up to allow
the wheels to turn freely.
1. 3. FITTING THE CANOPY
• Insert one of the two canopy side supports (D) into the tube provided on the chassis
(fig. 12) until it is correctly positioned around the tube.
• Do the same on the opposite side (fig. 13)
• Pull the canopy upwards until you hear it click into place on both sides (fig. 14)
• Fix the two press studs on each side of the back flap on the canopy at the points
provided on the seat padding (fig. 15 & 16)
1. 4. FITTING THE BUMPER
• Fit the bumper (E) into the housings provided (fig. 17 and 18), until the fixing
mechanisms click into place. Make sure it is properly secured by pulling it up at both
sides.
• To remove the bumper, press the side unlocking buttons (fig. 18), at the same time
pulling upwards.
• The safety guard can be opened without removing it completely, by releasing just
one side and turning it to the other side (fig. 19)
16