bebeduE NIK Manual Del Usuario página 18

INSTRUCTIONS
• Make sure the harness is properly fastened by pulling the buckle outwards.
• To release the harness press the button in the middle of the buckle (fig. 31)
• Adjust the belt and the chest straps if necessary by shortening or letting out the
appropriate tapes (fig. 31 & 32)
5. ADJUSTING HARNESS HEIGHT
• The harness has two height positions in order to adapt as your baby grows.
• To change the position, remove the chest strap from the back of the seat, by running
the end buckle through the slot in the seat back (fig. 33) until it is completely clear at
the front (fig. 34)
• Run the end buckle you have taken out through the slot in the new position, from the
front (fig. 35), until it is completely clear at the back (fig. 36)
• Repeat the above two steps with the chest strap on the other side.
• For newly-born or very young babies, the chest straps must be located in the bottom
position until the child is tall enough to use them in the top position.
6. FOLDING
• Lock the front wheels so that they cannot turn.
• Fold up the canopy and push it downwards into its lowered position (fig. 37)
• Place the seat back in its most vertical position (fig. 38)
• Press the two side buttons inside the handlebar, at the same time pushing the
handlebar down until it touches the chassis side tubes (fig. 39 & 40)
• Pull the tape located at the angle between the seat and the back, under the padding,
upwards (fig. 41), lifting the seat until it is folded.
• Set the safety lock fitted at one side (fig. 42)
• The chair will now be folded up, ready for transport or storage (fig. 43)
18