Publicidad
PROBLEM
The vehicle does not
start when the key is
turned to the ON
position.
The vehicle does not
start and the lights
flicker intermittently.
The vehicle was moving
but suddenly it stopped
or stalled.
Need Help? Write an e-mail to our product support department. service@injusa.com or info@injusa.com
Or call at (+34) 96 555 08 62 (Monday - Friday) 7:00 AM - 3:00 PM central Europe time.
POSSIBLE CAUSE
The battery
connections are
loose.
The battery
connections are well
connected, since some connector may have loosened due
connected but still
not working.
Possible failure of the
throttle or the
electronic control
plate.
The printed circuit
board is resetting.
2. Lift up the seat and disconnect the cables of the battery
Possible faulty
printed circuit board.
The engine sounds
strange and the
product does not
work.
Motor damaged.
First you must unscrew the seat and check the
connections of the battery (black connector with black
terminal and red connector with red terminal)
You should also check that the fuse is not blown.
Check that all the connections to the motor are still
to a knock. (it is located in the back right) If it is
disconnected, contact Injusa support service at
service@injusa.com or info@injusa.com
If after carrying out the previous checks, the motorcycle
still does not work, please contact the Injusa support
service at service@injusa.com or at info@injusa.com.
Wait until the intermittent flickering of the lights stops,
this means that the printed circuit board has been reset
and the vehicle will start as normal.
If the intermittent flickering of the lights does not stop
and the vehicle still won't start, the printed circuit board
will have to be reset manually, following these steps:
1. Turn the ignition key to the ON mode.
3. Turn the ignition key to the OFF mode.
4. Connect the cables to the battery terminals again.
5. Turn the ignition key to the ON mode.
6. Make sure the vehicle starts.
If after carrying out the previous checks, the motorcycle
still does not work, please contact the Injusa support
service at service@injusa.com or at info@injusa.com.
Please contact the Injusa support service at
service@injusa.com or at info@injusa.com to solve the
Please contact the Injusa support service at
service@injusa.com or at info@injusa.com to solve the
SOLUTION
(no current through the fuse)
terminals.
problem in a better way.
problem in a better way.
Publicidad
