Accessories; Safety Pod; Remote Control - ECOVACS WINBOT 7 Serie Manual De Instrucciones

5. Accessories

5.1 Safety Pod

Warning
If Winbot is used to clean a window above ground level, the Safety Pod MUST be used.
Winbot must be used in strict accordance with the directions in the Instruction Manual. Ecovacs Robotics, Inc. can not
be held liable or responsible for any damages or injuries caused due to improper use.
1. Make sure that there is enough power cord for the WINBOT to clean the entire window without restricting its movement.
If there is not enough cord, it is not safe to use the WINBOT on that particular window until a WINBOT Extension Cord is
attached (Extension Cord sold separately).
2. Loop one end of the Safety Rope around the Safety Pod's channel and pull it tight.
3. Loop the other end of the Safety Rope to the nut on the power cord and tighten. (If an Extension Cord is attached the
Safety Rope should still be tied to the nut on the power cord.)
EN
Note: Do NOT attach the Safety Rope to the thin part of the cord.
4. Press the Safety Pod suction cup FIRMLY on the inside, lower corner of the window. Make sure the Safety Pod suction
cup is securely in place.
5. Place WINBOT on the window, close the window, and start WINBOT.
6. After WINBOT is done cleaning remove it from the window. Grasp the handle, switch the unit OFF, insert finger into Air
Release Trigger and pull up on it for 20 seconds until suction has diminished.

5.2 Remote Control

Before using the remote control, please confirm that the batteries have been installed in accordance with the
diagram on the Remote Control casing.
The remote control uses two AAA batteries (provided).
●
If the battery power is low, replace both batteries. Never use a new battery with an old battery.
●
If the remote control is not used for a long period of time, remove the batteries during storage.
●
Should liquid be spilled on the Remote Control, remove the batteries immediately and shake so as much
●
of the liquid is out of the Remote Control as possible. Allow to dry for 24 hours before replacing the
batteries. Test the Remote Control with the unit on the window while the unit is within easy reach to see
that it works. If the Remote does NOT work, do not use the unit until the Remote has been replaced.
Please follow environmental regulations for the disposal of the used batteries.
●
4
5
6
OFF ON
11
TM
The Remote Control has a series of functions to become familiar with. The
1
Remote Control is very easy to use.
2
1. RESET button - Should the Winbot stop working in any way, the RESET button
3
can be pressed to restart the product and/or restore it to the factory defaults.
2. Start / Pause button - Starts and/or Stops the product.
3.4.5.6 Arrows - When pressed each arrow indicates the direction the unit will
move, remembering that the UP arrow corresponds to the front of the Winbot.
7. Pairing button - This button pairs the Remote Control with WINBOT.
7
Notice - The Remote Control is already paired with WINBOT when it arrives from
the factory. If you need to replace the Remote Control, please use the Pairing
button to pair the Remote Control with Winbot.
Pairing method:
Plug Winbot in and place Winbot's switch to the CHARGE position. Hold the Pairing
button on the Remote Control unit. Then press the Start/Pause button on Winbot
until Winbot beeps (about 3 seconds). Pairing action is complete when WINBOT beeps.
The Remote Control will work best when within 6.5 feet of the unit. Maximum
distance between Remote Control and Winnbot is 39.4 feet.