Back Up Battery Charge Status; Questions & Answers - ECOVACS WINBOT 7 Serie Manual De Instrucciones

11. Back Up Batter y Charge Status
To check the level of your Back Up Battery Charge, connect the Winbot to the Power Adapter and plug the Power
Adapter into an electrical receptacle. Place the Winbot's switch button, located under the handle, to the CHARGE
position (far right). If the Indicator Light flashes GREEN, the Battery needs to charge. Once the Back Up Battery is
fully charged, the Indicator Light will change to glow a continuous GREEN. You may then use the unit.
12. Questions and Answers
1. Can Winbot fall off the window during
cleaning?
Winbot is designed to keep from
encountering situations where it would
lose suction. If the power to the unit fails
during cleaning, the Back Up Battery has
enough stored energy to keep suction
until it can be attended to. When
cleaning the outside of a window higher
than ground level, the Safety Pod must
be used. The Safety Pod is a second line
of defense, in addition to the Back Up
Battery, to prevent the Winbot from falling
from a window. The Safety Pod also
allows for easy retrieval of the Winbot
from an outside window.
2. Can Winbot work without someone
present?
Winbot is designed to clean the window
without a person's physical assistance.
However, since the cleaning cycle does
not take a long time, it is recommended
that a person remain in the vicinity so
when the Winbot is done it can be
removed from the window and/or
attended to.
3 . Can the product be used on any glass
thickness? (windows, sliding glass
doors, etc)
Winbot can be used on any glass
thickness. However, windows with an
uneven surface, such as frosted,
textured, patterned or leaded glass are
not suitable to be cleaned by the Winbot
as the uneven surface will cause the unit
to lose suction and fall from the window.
4 . Why does the Winbot send out "toot"
alarm and the Indicator Light flash
RED after just starting the product?
Please refer to the Common Malfunctions
section of this Instruction Manual where
indicator sounds and lights are covered
in more detail.
5 . Winbot has been placed on the window
but is NOT working and the Indicator
Light has not turned BLUE. What does
this mean?
If this occurs, it means that the suction
power has been compromised. Please
examine the Winbot's Cupule and Driving
Treads for accumulated dirt or dust which
would cause the unit to lose suction and
stop working. Clean the Cupule and
Driving Treads in accordance to the
Product Maintenance section (section 7)
in this Instruction Manual.
6 . Winbot was placed properly to the
window and the START button was
pressed, but the unit moved to the
bottom of the window and failed to
work. What happened?
Winbot will not clean the window if it is
not plugged into a receptacle. Its Back Up
Battery will send the unit to the bottom of
the window and it will go into stand-by
mode. Should this happen, plug the
Power Adapter into a receptacle for
power and restart the cleaning cycle by
pushing the START button on the unit or
on the Remote Control. Make sure that
the Winbot has enough supply cord to
clean the entire window without pulling
on the Adapter.
7 . What happens if Winbot encounters an
obstruction like a window lock or
handle?
Under normal circumstances, Winbot will
automatically maneuver around the
obstruction and continue its cleaning
process.
Live Smart. Enjoy Life.
EN
16