ECOVACS WINBOT 7 Serie Manual De Instrucciones página 18

8. What happens if Winbot encounters
curtains or blinds?
Please make sure there is 4" clearance
between the window and curtains so
Winbot can move freely on the window.
Blinds/shades must be pulled completely
open. Outside windows should have 4"
clearance between window and any
outdoor plants or shrubs.
9. Can Winbot clean rounded glass or
glass that is mounted on an angle?
Winbot is not intended for use on rounded
glass or glass that is mounted at an
angle. Do not use Winbot upside down.
10. Can I use Winbot W710 on a frameless
window?
Winbot W710 can only be used on framed
windows. Winbot W730 can be used on
both framed and frameless windows.
EN
11. Winbot didn't clean the window
completely, or left streaks, what
happened?
Winbot is NOT intended to replace
heavy duty or first time cleaning, this
needs to be done by hand as you have
done in the past. Winbot is designed
for maintenance cleaning on standard
windows. Winbot can NOT be used to
clean stains such as paint, or windows
with stickers attached, as these may
cause suction failure. For streaking,
reduced cleaning ability and other
issues, please refer to the Common
Malfunctions section (section 10) in this
Instruction Manual. The majority of these
issues can be avoided with regular
maintenance detailed in the Product
Maintenance section (section 7).
12. How should Winbot be stored when not
in use?
Place Winbot's switch under the handle
in the OFF position (far left) and clean the
unit as described in the Product
Maintenance section (section 7) in this
Instruction Manual. Then store Winbot in
its original box a cool, dry place away
from liquids and direct sunlight.
13 . When Winbot is cleaning an outside
window and the alarm goes off
indicating a problem, what happens if I
can't hear it?
17
TM
Winbot is equipped with both audio and
visual indicators should a problem occur.
For added convenience, there are two
visual Indicator Lights - one on each side
of the unit - so if the Winbot is working
outside the Indicator Light on the bottom
of the unit can still be seen inside.
14 . If Winbot gets into trouble, sounds
and/or flashes an alarm and stops,
cleaning, what should I do?
It is possible for Winbot to get into trouble
when cleaning. In most cases, it can get
out of trouble on its own, but if that fails,
the cleaning cycle will be stopped and an
alarm will indicate that assistance is
necessary. Consult sections Meaning of
Indicators and Alarms and Solutions
(section 8 and 9) in this Instruction
Manual to determine what to do.
15 . Can Winbot clean completely, even in
the corners of the window? What can I
do if Winbot misses a spot?.
Winbot is programmed to clean the
windows as completely and efficiently as
possible. However, in some
circumstances, corners may not be
completely cleaned or a spot may be
missed. Once the unit has finished its
cleaning cycle, use the Remote Control
to maneuver the Winbot it to the spots
that need to be attended to using the
ARROW buttons.
16 . Where can I purchase accessories,
additional parts, or find a factory
approved repair center?
Please contact Customer Service at 1-
888-966-0895 or visit www.ecovacs.com.
to purchase additional parts and
accessories or find a factory approved
repair facility. Please have the model
number and product number that you
recorded on the Welcome Page of this
manual available.
If you have questions or concerns that are
not addressed in this Manual, we welcome
your questions and comments. Please
contact Customer Service 1-888-966-0895
so that we may address any concerns you
may have.
Thank you for your purchase of the
Winbot 7 Series. We hope you enjoy it
for years to come.