Technical Specifications - HURAKAN HKN-FR1GM Manual Del Usuario

EN
INTRODUCTION
DEAR ALL,
Before you start operating this quipment, you should read and understand this Certificate
and keep it during the whole service life.
Please keep in mind that observance of the instructions presented in this Certificate
extends the service life of the equipment and prevents injury of operating personnel.
We hope our recommendations will maximally facilitate operation of the equipment.
APPLICATION
! This equipment is designed for use at public catering enterprises and used for mixing
milkshakes and whipping cream.

TECHNICAL SPECIFICATIONS

Model
Description
Overall dimensions, mm
Generating capacity, kW
Power supply network
parameters
Case material
Glass material
Glass volume, l
Number of spindles
Maximum time of
continuous operation, sec
Mass, kg
OPERATION PROCEDURE
BEFORE FIRST START
1. Unpack the equipment, remove all the packaging materials.
2. Clean the equipment in accordance with the instructions presented in the "Maintenance
and care" section.
SWITCHING THE EQUIPMENT ON
1. The equipment shall be installed on a stable support 800-900 mm in height with flat level
surface. The surface shall be dry and clean. The support shall withstand the equipment
weight.
2. Make sure that the power switch is in 0 position (off). Turn on the power (put the male
connector into the female socket).
3. Put ingredients (milk, ice cream, syrup, sugar, etc.) in a glass.
Avoid filling with hot liquids.
Do not use solid, water-insoluble ingredients.
The glass should not be filled more than half as the volume of the mixture increases with
whipping.
4. Put the beaker in a plastic holder on the equipment body.
It is prohibited to turn on the mixer without a glass.
5. Energize the equipment using the power switch. As the equipment motor is rotating at
high speed, the top cover of the working head should be slightly held during operation.
Typically, the cooking time of a milkshake is about 5 seconds.
8
HKN-FR1GM
Desktop
160*190*520
0.15
220/50/1
Aluminium
Stainless steel
1.0
1
60
3.5
HKN-FR2GM
360*190*520
2x0.15
220/50/1
Aluminium
Stainless steel
2x1.0
2
60
6.5