Avtech IC-AVH516 Manual De Instrucciones página 40

SNMP V1/V2
Select "ON" to enable this function, and enter the names of "READ COMMUNITY" and "WRITE COMMUNITY"
based on your NMS configurations.
To enable TRAP to notify the management station of important events, choose "V1" or "V2C" in "TRAP ENABLE",
enter the address and community name, and select the event type(s) needed.
CONNECTION WAN LAN E-MAIL DDNS NETWORK MONITOR
CAMERA ENABLE
DETECTION READ COMMUNITY
ALERT
WRITE COMMUNITY
NETWORK TRAP ENABLE
DISPLAY TRAP ADDRESS
RECORD TRAP COMMUNITY
NOTIFY TRAP COLD START
MULTICASTING TRAP WARM START
TRAP LINK UP
TRAP AUTHENTICATION FAILED
EXIT
SNMP V3
SNMP V3 has a higher security level than SNMP V1 / V2C to allow configuring the authentication password and
encryption password.
Choose "Read/Write Security name" or "Read only Security name" based on your NMS settings, and enter the
community name. Then, select the authentication type from "MD5" or "SHA", and enter the password for
authentication and encryption. The password length is from 8 to 31 characters.
CONNECTION WAN LAN E-MAIL DDNS NETWORK MONITOR
CAMERA ENABLE
DETECTION READ/WRITE SECURITY NAME
ALERT
READ/WRITE AUTHENTICATION TYPE
NETWORK READ/WRITE AUTHENTICATION PASSWORD
DISPLAY READ/WRITE ENCRYPTION PASSWORD
RECORD READ ONLY SECURITY NAME
NOTIFY
READ ONLY AUTHENTICATION TYPE
MULTICASTING READ ONLY AUTHENTICATION PASSWORD
READ ONLY ENCRYPTION PASSWORD
EXIT
ADVANCED CONFIG
ADVANCED CONFIG
34
SNMP V1/V2 SNMP V3 RTP
ON
Public
private
NO
SNMP_trap
ON
ON
ON
ON
SNMP V1/V2 SNMP V3 RTP
ON
Private
SHA
●●●●●●●●
●●●●●●●●
Public
MD5
●●●●●●●●
●●●●●●●●
MAIN MENU