Abicor Binzel ABIPLAS WELD CT Serie Instructivo De Servicio página 33

®
ABIPLAS WELD CT
6.2 Equipping torch body
1
Fig. 4 Steps of equipping the torch body ABIPLAS
®
WELD CT 250 CT20
ABIPLAS
2-4
1 Insert tungsten electrode with the blunt end into the torch cap about 5mm
deep.
2 Slide both parts into the torch body and screw down with torch cap.
3 Unscrew screwed-in torch cap half a turn counter clockwise.
4 Slide centring ceramics from below into torch body.
5 Screw alignment gauge onto torch body as far as it will go. This pushes the
tungsten electrode back to the preset setting dimension.
NOTE
• The standard setting dimension for the electrode setting is 3 mm.
6 Tighten torch cap. Tungsten electrode is clamped.
7 Unscrew alignment gauge.
8 Insert insulating ring, screw in distributor ring and gas diffuser.
9 Insert plasma nozzle and tighten it by means of the fastening nut.
10Screw down gas nozzle.
5-7
3mm
®
WELD CT 250 CT20
6 Putting into operation
7-10
EN - 11