Abicor Binzel ABIPLAS WELD CT Serie Instructivo De Servicio página 35

®
ABIPLAS WELD CT
6.4 Mounting the torch body at the complete fastener
1
16
15
14
13
1 Torch body (equipped)
2 Connection nut
3 2 cylinder screws M5x20
4 Complete fastener
5 Cable assembly
6 Nut M10x1
Fig. 6 Mounting Plasma segment holder
2 3
12
7 Guide tube
8 Set screw
9 Nut M10x1
10 Guide
11 Knurled screw
1 Fasten the complete fastener (4) to the robot
2 Introduce guide tube (7) from behind through the bore of the complete
fastener (4), screw it down and secure it with the set screw (8).
3 Unscrew cylinder screws (3) and slide cable assembly (5) through the
complete fastener (4) as far as it will go. Positioning is possible in 90° steps.
4 Connect the cable of the safety switch-off circuit to the CAT torch mount.
5 Introduce torch body (1) from the front into the cable assembly (5) and
secure it with connection nut (2).
6 Fix fastener (16) to torch neck (1) with cylinder screws (14). Use fastener
(16) only with ABIPLAS
7 Screw guide (10) to guide tube (7) with nut (9).
8 Screw knurled screw (11) of the cold-wire feeder (12) into fastener (16).
4
11
12 Cold-wire feeder
13 Nozzle
14 2 cylinder screws M4x8
15 Cylindrical pin 4m6x10
16 Fastener
®
WELD CT 250 CT20.
6 Putting into operation
10
EN - 13
5
6
7
8
9