Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8 Putting out of operation
8 Putting out of operation
9 Maintenance and cleaning
EN - 18
NOTE
®
• As the ABIPLAS
welding system, putting out of operation depends on the robot control
system. Please make sure that the shutdown procedures for all
components integrated in the welding system are strictly observed.
1 Switch off main current and pilot current.
2 Switch off the power supply.
3 Close the shut-off valves for the gas supply.
Regular and lasting maintenance and cleaning are the prerequisite of a long
life and a trouble free operation.
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply.
• Cut off the gas supply.
• Cut off the compressed air supply.
• Pull the mains plug.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation.
• Replace any damaged, deformed or worn parts.
NOTE
• The maintenance intervals given are approximate values and refer to
single-shift operation.
• Maintenance and cleaning work may only be carried out by qualified
and trained specialists.
• Always wear your personal protective clothing when performing
maintenance and cleaning work.
WELD CT welding torches are integrated into a
®
ABIPLAS
WELD CT
Publicidad
Tabla de contenido
