Publicidad
Connect branch A2 and branch A3 to the supplied black 2-pin socket housing (1) as follows:
Branch A2, 1-pin socket contact, white/brown wire, to PIN 2
Branch A3, 1-pin socket contact, red/white wire, to PIN 1
Tie back supplied black 2-pin socket housing (1) with connected branches A2 and A3 from changeover module A
on vehicle wiring harness (not required).
Fig. C
b
The figure shows the front left entrance on an LHD vehicle, follow the same procedure on RHD vehicles.
b
Follow specified sequence.
The two supplied shrink-fitted tubes (1) must be fitted on branches A9, 1-pin socket contact, blue wire and A10,
1-pin socket contact, blue/brown wire, from changeover module A.
Fig. D
b
The figure shows the door isolating connector on the driver's side on an LHD vehicle, follow the same
procedure on RHD vehicles.
Release black 8-pin speaker connector X18196 on LHD vehicles or X18198 on RHD vehicles from door isolating
connector (1) as illustrated and slide out.
Fig. E
b
The figure shows the door isolating connector on the driver's side on an LHD vehicle, follow the same
procedure on RHD vehicles.
On LHD vehicles
Unplug pin contact (1) of speaker cable (2), blue/white wire, from PIN 28 of black 8-pin speaker connector X18196.
Connect unplugged 1-pin pin contact (1), blue/white wire, from speaker cable (2) to branch A9, 1-pin socket contact,
blue wire, from changeover module A.
Connect branch A11, 1-pin pin contact, blue wire, from changeover module A to black 8-pin speaker connector
X18196 at PIN 28.
Unplug pin contact (3) of speaker cable (2), blue/brown wire, from PIN 29 of black 8-pin speaker connector X18196.
Connect unplugged 1-pin pin contact (3), blue/brown wire, from speaker cable (2) to branch A10, 1-pin socket
contact, blue/brown wire, from changeover module A.
Connect branch A12, 1-pin pin contact, blue/brown wire, from changeover module A to black 8-pin speaker
connector X18196 at PIN 29.
Re-insert black 8-pin speaker connector X18196 with connected branched A11 and A12 from changeover module A
in door isolating connector (4) in direction indicated by arrow.
Reassemble door isolating connector (4)
On RHD vehicles
Unplug pin contact (1) of speaker cable (2), blue/red wire, from PIN 28 of black 8-pin speaker connector X18198.
Connect unplugged 1-pin pin contact (1), blue/red wire, from speaker cable (2) to branch A9, 1-pin socket contact,
blue wire, from changeover module A.
Connect branch A11, 1-pin pin contact, blue wire, from changeover module A to black 8-pin speaker connector
X18198 at PIN 28.
Unplug pin contact (3) of speaker cable (2), blue/brown wire, from PIN 29 of black 8-pin speaker connector X18198.
Connect unplugged 1-pin pin contact (3), blue/brown wire, from speaker cable (2) to branch A10, 1-pin socket
contact, blue/brown wire, from changeover module A.
Connect branch A12, 1-pin pin contact, blue/brown wire, from changeover module A to black 8-pin speaker
connector X18198 at PIN 29.
Re-insert black 8-pin speaker connector X18198 with connected branches A11 and A12 from changeover module A
in door isolating connector (4) in direction indicated by arrow.
Reassemble door isolating connector (4)
c
c
c
c
EN 2-33
Publicidad
Capítulos
