Kobalt SGY-AIR88 Manual Del Usuario página 7

TROUBLESHOOTING
PROBLEM
a) Gun improperly adjusted.
b) Dirty air cap.
c) Fluid tip obstructed.
d) Sluggish needle.
Fan adjustment screw not seating
properly.
a) No air pressure at gun.
b) Fluid pressure too low with
internal mix cap and pressure tank.
c) Fluid control screw not open enough.
d) Fluid too heavy for suction feed.
a) Packing nut loose.
b) Packing worn or dry.
a) Dry packing.
b) Sluggish needle.
c) Tight packing nut.
d) Worn fluid nozzle or needle.
a) Gun held too far from surface.
b) Atomization pressure set too high.
Gun held too close to surface.
WARNING
SOME DUST CREATED BY POWER SANDING, SAWING, GRINDING, DRILLING AND OTHER RELATED ACTIVITIES CONTAINS
CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. SOME
EXAMPLES OF THESE CHEMICALS ARE:
LEAD FROM LEAD-BASED PAINTS
CRYSTALLINE SILICA FROM BRICKS, CEMENT AND OTHER MASONRY PRODUCTS
ARSENIC AND CHROMIUM FROM CHEMICALLY-TREATED LUM BER
YOUR RISK FROM THESE EXPOSURES VARIES, DEPENDING ON HOW OFTEN YOU DO THIS TYPE OF WORK.
TO REDUCE YOUR EXPOSURE TO THESE CHEMICALS, WORK IN A WELL VENTILATED AREA, AND WORK WITH APPROVED SAFETY
EQUIPMENTS, SUCH AS THOSE DUST MASKS THAT ARE SPECIALLY DESIGNED TO FILTER OUT MICROSCOPIC PARTICLES.
SPRAY PATTERN/
CONDITION
Improper spray
pattern.
Unable to get
round spray.
Will not spray.
Fluid leakage
from packing nut.
Dripping from
fluid tip.
Thin, sandy
coarse finish.
Thick, dimpled
finish resembling
orange peel.
7
SOLUTION
a) Re-adjust gun. Follow instructions
carefully.
b) Clean air cap.
c) Clean.
d) Lubricate.
Clean or replace.
a) Check air supply and air lines.
b) Increase fluid pressure at tank.
c) Open fluid control screw.
d) Thin material or change to pressure feed.
a) Tighten, but not so tight as to grip needle.
b) Replace packing or lubricate.
a) Lubricate.
b) Lubricate.
c) Adjust.
d) For pressure feed, replace with new fluid
nozzle and needle.
a) Move gun closer to surface.
b) Adjust atomization pressure.
Move gun further from surface.