Kobalt SGY-AIR88 Manual Del Usuario página 2

WARNING - FOLLOW THESE RULES FOR SAFE OPERATION !
High sound levels can cause permanent hearing loss. Wear ear protection.
Whenever possible, secure work with clamps or vise so both hands can be free to operate
the tool.
Repetitive work motions, awkward positions and exposure to vibration can be harmful to
hands and arms.
Avoid inhaling dust or handling debris from work processes which can be harmful to your health.
Operators and maintenance personnel must be physically able to handle the bulk, weight and power of
the tool.
This tool is not intended for using in explosive atmospheres and is not insulated for contact with electrical
power sources.
Solvent and coatings can be highly combustible especially when sprayed.
Adequate exhaust must be provided to keep air free of flammable vapors.
Do not smoke in or near the work area. Always keep a fire extinguisher present in the work area.
Never spray near sources of ignition such as pilot lights, welders, and etc.
Halogenated hydrocarbon solvents, for example, methylene chloride, are not chemically
compatible with the aluminum that might be used in many system components. The
chemical reaction caused by these solvents reacting with aluminum can become
dangerous and lead to an equipment explosion. Guns with stainless steel fluid passages
may be used with these solvents. However, aluminum is widely used in other spray application equipment
such as material pumps, cups and regulators, valves, and etc. Check all other equipment items before use
and make sure they can also be used safely with those solvents. Read the label or material safety data
sheet for the material you intend to spray.
If in doubt as to whether or not a coating or cleaning material is compatible, contact your material supplier.
Sprayed materials may be harmful if inhaled, or if there is contact with the skin. Adequate
exhaust must be provided to keep the air free of toxic materials. Use a mask or respirator
whenever there is a chance of inhaling sprayed materials. The mask must be compatible
with the material being sprayed and its concentration.
1.DO NOT REMOVE Brass baffle attached to front of gun body as special technical training and tools are
required. Only authorized service centers should remove this part.
2.To avoid cross-threading, all spray gun parts should be screwed in hand tight initially. If the parts can not
easily be turned by hand, be sure you have the correct parts, unscrew, realign, and try again. Never use
excessive force in matching parts.
PREPARATION
Before beginning assembly and operation of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble
or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 3 minutes
Tools Required for Assembly: Wrench (included)
CAUTION
2