Amann Girrbach SUCTION Modo De Empleo página 9

SUCTION
On/Off switch
!
Adjustable extraction control
@
Re-set button (safety switch)
#
Handle
$
Flap for changing the filter bag/
%
Micro filter
Socket for control cable (for automatic
^
operation in the milling machine)
Mains cable socket
&
Point of connection for extraction tube
*
Suction adapter (Art. No. 179601) for connec-
(
tion to the required unit (not included in the
delivery contents of the extraction unit)
Extraction support for filter bag
BL
Micro filter
BM
Flap for changing the carbon brushes
BN
PRODUCT DESCRIPTION
The extraction is suitable for use with a dental
milling machine.
The separate mains cable attachment allows
automatic operation with the milling machine.
The extraction unit has a special filter bag and a
HEPA micro filter, which filters up to 99.97 % of
fine dust particles (i.e. zirconium oxide dust
particles) and is classified in the fine dust particle
category M.
U S E R M A N U A L
INITIAL OPERATION
After unpacking the unit, please check for possible
transport damage. Should you find any damage,
please claim the damage from your supplier
immediately. The extraction unit is available
in 2 voltage strengths (100 - 120V and 230V).
Before connecting to a power source, please check
whether the voltage on the type plate at the
back of the housing corresponds to your voltage,
and make sure the ON/OFF switch is OFF.
TUBE CONNECTION
Connect the extraction tube at the designated
connection point directly to the extraction
&
unit and the conical side to the chosen device by
means of the supplied adapter
ELECTRICAL CONNECTION
Manual Operation
Connect the extraction
using the enclosed mains cable. The extraction
unit is put into operation using the ON/OFF
switch at the positions ON/OFF.
!
.
(
to the power source
&
EN
9