Replace The Button Assembly; Five Year Limited Warranty - Kohler K-10675 Guía De Mantenimiento

Valve Body
Flush Button
Assembly
Holes

Replace the Button Assembly

Close the control stop valve.
NOTE: If the unit has not flushed since the stop valve was closed,
the inlet arm may still be pressurized. Use manual flush button to
release pressure.
Carefully place a properly sized spanner wrench or a pair of
needle-nose pliers into the holes on the end of the flush button.
Remove the flush button assembly from the valve body.
NOTE: The flush button can only be serviced as a complete
assembly. There are no serviceable internal parts.
Carefully thread a new flush button assembly into the valve body.
Tighten with a spanner wrench or needle nose pliers.
Open the control stop valve.
Verify the valve functions.

Five Year Limited Warranty

KOHLER Electronic Faucets, Valves and Controls
®
FIVE-YEAR LIMITED WARRANTY
Kohler Co. warrants that its electronic faucets, valves and controls will
be free of defects in material and workmanship during normal
residential use for five years from the date the product is installed.
This warranty applies only to electronic faucets, valves and controls
Kohler Co. 17 1108712-5-C