Tools Required - Starmix NSG Serie Manual De Instrucciones

en
1. Set required operating mode on the switch.
9 Vacuum cleaner is ready for vacuuming.
2. To adjust the suction power, select from the following options (depending on equipment):
– Move switch to ECO position
– Set speed on the switch
– Set auxiliary air slide on the handle tube
Suck up liquids
Volume of liquid
Small volume of liquid
Large volume of liquid
1. Remove filter bag from the dirt container before sucking up liquids.
2. Slightly open auxiliary air slide on the handle.
3. Move switch to position I.
Before switching off the vacuum cleaner:
1. Remove suction nozzle from the liquid.
9 Residual water in the suction hose is sucked into the container and cannot leak out.
If there is a sudden loss of suction power and increased motor speed (changed motor noises), the float valve
has interrupted the suction process: The container is full.
1. Switch vacuum cleaner off.
2. Empty dirt container and filter cartridge.
Connect an electrical tool
See Fig. C.
Use socket on vacuum cleaners with automatic switch on/off (switch position A) to connect electrical tools. The
vacuum cleaner is switched on and off by the electrical tool. In switch position 0, the socket can be used as an
extension cable, e.g. for a light.
Connection value: Vacuum cleaner + electrical tool = max. 16 A (value depends on the country version, pay
attention to technical data).
WARNING!
The socket on the vacuum cleaner is always live.
Risk of injury due to electrical tool automatically starting up.
1. Before plugging in: Switch off electrical tool.
Smart Stop
See Fig. D.
1. Apply the brake with your foot.
9 The vacuum cleaner is prevented from rolling away.
Smart Stop offers further functions:
– Handle to empty the dirt container
– Ramp function to drive over obstacles
16

Tools required

Main filter (filter cartridge)
Water nozzle
Main filter (foam)
Water nozzle