Dash Disassembly - Metra 99-5721 Instrucciones De Instalación

1. Unclip and remove the (2) trim
panels on the left and right side
of the cup holders and shifter.
(Figure A)
2. Unclip and remove the trim
panel to the right of the
passenger a/c vent. (Figure B)
3. Unclip and remove the knee
bolster panel below the
steering column. (Figure B)
4. Remove (1) 9/32" screw from
the trim panel to the left of the
steering column that has the
interior light dimmer switch in
it.
5. Unclip and remove the trim
panel between the steering
column and the key cylinder.
(Figure C)

Dash Disassembly

(Figure A)
(Figure B)
(Figure C)
®
99-5721
6. Unclip and remove the gauge
cluster trim panel. (Figure D)
7. Unclip and remove the trim
panel/speaker grill from above
the radio trim panel. (Figure D)
8. Remove (4) Phillips screws
from the cup holder trim panel
then unclip and remove the
panel. (Figure E)
9. Remove (4) Phillips screws
from the shifter trim panel then
slide it backwards.
Note: There is no need to
remove this panel completely.
(Figure F)
2
(Figure D)
(Figure E)
(Figure F)