Kit Preparation - Metra 99-5721 Instrucciones De Instalación

Dash Disassembly
10. Remove (4) Phillips screws
from the ash tray trim panel
then unclip and remove the ash
tray assembly. (Figure G)
11. Remove (10) phillips screws
from the radio trim panel
including the a/c vents then
unclip and remove the panel.
(Figure H)
Note: The harness that is connected
to this panel will connect to the
climate extension harness, and then
into the radio/housing climate panel.
12. Remove (4) Phillips screws
securing the radio display.
(Figure I)
13. Remove (4) Phillips screws
securing the radio. (Figure I)
14. Unclip and remove the a/c
vents and chrome vent trim
from the factory panel.
(Figure G)
(Figure H)
(Figure I)
®
99-5721

Kit Preparation

1. Secure the left and right
a/c vent trim panels to
the radio/climate housing
panel using the supplied
(10) #8X3/8" Phillips
screws. (Figure A)
2. Snap the a/c vents and
chrome vent trim into
the appropriate vent trim
panel.
Note: The vents are
labeled L and R on the
tops.
3
(Figure A)