Customizing The Display - Metra 99-5721 Instrucciones De Instalación

Changing The Display Back Light Color
1. Press the Passenger Heated Seat button for 10 seconds, the unit will go into
"Configure Backlight Color" mode. The display will show "Red Green Blue"
with number assigned to each color contributing to the overall back light
color while in this mode. Each number will be between 0-255.
2. Press and hold the Fan + button to increase Red.
3. Press and hold the Fan - button to decrease Red.
4. Press and hold the Front Defrost button to increase Green.
5. Press and hold the Power button to decrease Green.
6. Press and hold the Rear Defrost button to increase Blue.
7. Press and hold the Driver Heated Seat button to decrease Blue.
8. After you choose your color stop pressing the buttons and after 10 seconds
the color chosen will stay.
Changing The Display Contrast
1. Press the Driver Heated Seat button for 10 seconds, the unit will go into
"Configure Display Contrast" mode.
2. Press the Temp +/- buttons to adjust the display contrast up and down.
3. After 10 seconds of no buttons being pressed the chosen contrast will stay.
Main Screen Text Customization
1. Press and hold the MAX A/C button for 10 seconds. The current home
screen will then be displayed and the cursor will appear and blink. It will be
located in the 1st location on the top row.
2. To modify the text :
A. Use the FAN buttons to move the cursor forward or back. The
®
99-5721

Customizing The Display

•
•
•
•
3. To exit this mode:
4. To erase any changes made to the default display – Press and hold down
the recirculation button button for 15 seconds. The "TAURUS" will once
again be the default display.
NOTE: Characters are saved into memory immediately whenever changes are
made.
NOTE: While in this mode – no other display items will be updated.
Dual Zone Temperature Controls
(allows 99-5721 to operate in a dual-zone climate controlled car)
1. Press the Temp Down and Passenger Heated Seat button simultaneously to
enter Dual Zone Set Mode. Note: The ZONE icon will light to indicate that
you are in dual zone mode, and the temperature bar graph will flash.
2. Press the Temp Up and Temp Down buttons to set the passenger
temperature set point.
7
location where the cursor is blinking is the location that the character
may be changed.
FAN DOWN = Move Cursor ahead one location
FAN UP = Move Cursor back one location
B. To change the character where the cursor is currently blinking use the
TEMP buttons to progress through the character set.
TEMP UP = Show the next character
TEMP DOWN = Show the previous character
A. Do not press ANY buttons for 15 seconds and it will timeout
automatically.
B. Press button other than the 4 mentioned above.
(Continued on page 8)