Adjusting Mount Extension - PEERLESS PARAMOUNT PPA Manual Del Usuario

Attaching Adapter Plate to Projector Mount (continued)
guide hook slots of pivot/roll bracket (F) onto M5 x 10 mm screws in hanger bracket (D or E) as shown in figure 8.1
8
for ceiling installation or figure 8.2 for wall installation. Fasten two socket pin screws (L) through slot in pivot/roll
bracket (F) and into hanger bracket (D or E).
• Do not lift more weight than you can handle. Use additional man power or mechanical lifting equipment to safely
handle placement of the projector.
CEILING INSTALLATION
fig. 8.1
HOOk SLOTS

Adjusting Mount Extension

While supporting the weight of the projector, loosen screws on clamp plate (G) half a turn and position projector to
9
the desired extended position. Retighten clamp plate screws securely.
• On ceiling installations, clamp plate adjustment screws support weight of projector when fully tightened. Weight of
the projector will need to be supported if clamp plate screws are loosened.
CEILING INSTALLATION
CLAMP PLATE
SCREWS
Visit the Peerless Web Site at www.peerlessmounts.com
WARNING
WALL INSTALLATION
D
(ExCEPT FOR PPC MODELS)
fig. 8.2
HOOk SLOTS
F
L
HOOk SLOTS
WARNING
WALL INSTALLATION
(ExCEPT FOR PPC MODELS)
G
10 of 33
E
CLAMP PLATE
SCREWS
ISSUED: 12-26-07 SHEET #: 055-9494-1
For customer care call 1-800-865-2112 or 708-865-8870.
F
L
G