Steelcase Answer Manual Del Usuario página 5

®
Installation for Non-Recessed
Back Storage
NOTE: Storage units can be connected to the
beam with either one left hand or one right hand
bracket.
1.
Inventory and stage all lower storage units and
storage brackets.
2.
Flip the bracket upside down and nest it on the
proper corner, gauge it to the underside of the top,
and mark the top "T" hole for a 1 High, or the "1"
hole for a 1.5 High, or the "2" hole for a 2 High.
3.
Gauge the bracket to the bottom of the unit and
mark the bottom "B" mounting hole.
4.
Remove the bracket and drill 5/16" diameter
holes at the two (2) marked locations.
2
3
Page 5 of 40
100117 Rev A