Led A And Led B Status Display; Operation; Connection Diagram - Bosch KTS 5 Serie Manual Original

3.5.3

LED A and LED B status display

Status LED A
KTS 5xx ready for Off

operation

Data communica- Flashing green
tion with control (irregular)
unit
Firmware update Off
in progress
LED A Function
Off No data communica-
tion with control unit
Flashing green Data communica-
(irregular) tion with control
unit
Green light Fault in hardware/
Firmware
Red light Voltage
supply > 35 V
LED B Function
Off No voltage supply
Flashing green KTS 5xx ready for
(1 second frequen- operation
cy)
Green light Fault in hardware/
Firmware
Flashing yellow Overvoltage at
(1 second frequen- Diagnostic cable
cy)
Yellow light Fault in hardware/
Firmware
Flashing red Firmware update
(irregular) in progress
Red light Fault in firmware-
Update
Unplug USB connection and power supply and plug in again. If
1)
the error still exists, contact customer service.
Robert Bosch GmbH
Device description | KTS 530 / 540 / 570 (KTS 5 Series) | 19
3.6
KTS 530 can be connected to the PC/laptop only via the
LED B
USB interface.
Flashing green
The KTS 540 / 570 can be connected to a PC/laptop
(1 second frequen-
by way of a radio link (Bluetooth) or the USB interface.
cy)
For a radio link, the Bluetooth USB adapter has to be
Flashing green
plugged into the PC/laptop.
(1 second frequen-
cy)
i
Flashing red
The radio link between the KTS 540 / 570 and the PC/
(irregular)
laptop can only be established using the Bluetooth
USB adapter included in the scope of delivery. The
Measure
Bluetooth USB adapter supplied is not required for a
Check connection
DCU 100 / DCU 220 with internal Bluetooth hardware
to control unit
and the Bluetooth driver does not have to be installed.
None
3.6.1
1)
Check voltage in ve-
hicle
Measure
Check the voltage
supply
None
1)
1)
1) 11
None
Repeat firmware
update
Fig. 3:
1 OBD interface in motor vehicle
2 UNI connection cable
3 OBD connection cable
4 Measurement cables (KTS 570)
5 Measurement cables (KTS 530 / KTS 540)
6 Ground cable
7 Power supply unit
8 Adapter insert (IBOX 01)
9 KTS 570
10 USB connection cable
11 Bluetooth USB adapter
12 PC (Laptop)
!
Only use the UNI connection cable (fig. 3, item 2) for
measurements with less than 30 V.
Operation

Connection diagram

1
1
9
2
10
3
11
12 4
13 5
14
6
15
7
16
8
X9
12
V
BOSCH
I
D
E
O 5
X2 Mouse X7 LPT1
X25 USB1
1
X1 K ayboard X3 COM1 X4 COM2
0
X26 USB2
10
9
8
7
Connection diagram in an example for the KTS 570
1 689 979 987
en
3
2
4
6
|
2015-09-22