Kit Assembly - Metra 99-7810B Instrucciones De Instalación

1. Attach the radio trim panel brackets
to the radio trim panel using (4)
#6 x 3/8" Phillips screws supplied.
(Figure A)
2. Attach the rear support bracket
to the radio trim panel brackets
using (4) #6 x 3/8" Phillips screws
supplied. (Figure B)
3. Attach the pocket to the bracket/
panel using the (4) #8 x 3/8"
Phillips screws supplied. (Figure C)
4. Remove the metal "DIN" sleeve
and trim ring from the
aftermarket radio.

Kit Assembly

(Figure A)
(Figure B)
99-7810B
5. Slide the radio into the completed
assembly, and then secure it to
the assembly using the screws
supplied with the radio. (Figure D)
6. Locate the factory wiring harness
and antenna connector in the
dash, and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Re-connect the negative
battery terminal and test the radio
for proper operation.
7. Reassemble the dash in reverse
order of disassembly.
3
(Figure C)
(Figure D)