Section 5. Programming The Chemlink; To Configure The Chemlink - Zodiac C1900 ChemLink ORP and pH Manual De Instalación Y Del Usuario

Page 12
ENGLISH
J 2
Figure 11. ORP Jumper 14 and ORP Connector
J15
C1900 ORP and pH ChemLink™ Controller
Power Center
Wires to the
external
ORP Controller
ORP
Connector J15
ORP
Jumper J14
Chlorine Generator
Power Interface Board
|
Installation & Operation Manual

Section 5. Programming the ChemLink

The AquaLink will automatically recognize the
®
ChemLink once the cable connection has been made.
The main AquaLink screen will alternate between the
main screen and the Equipment Status screen.
EQUIPMENT STATUS
FILTER PUMP
CHEMLINK 1
ORP/350 PH/7.6
NOTE The screens shown in this sections are of the
OneTouch™ control, however these instructions
apply to the PDA as well. The display on the PDA
remote is a smaller, but selections are the same.
5.1 To Configure the ChemLink
NOTE Check with the installer before making changes to
the SYSTEM SETUP.
Highlight MENU/HELP and press SELECT. Highlight
SYSTEM SETUP and press SELECT. Using the arrow
keys or PAGE UP or PAGE DOWN keys, highlight
CHEMLINK and press SELECT.
NOTE If only one ChemLink is present in the system, the \
main ChemLink screen is displayed.
ZODIAC AquaLink RS
01/31/03 MON
6:00 PM
FILTER PUMP OFF
AIR 79°F
EQUIPMENT ON/OFF
ONETOUCH ON/OFF
MENU / HELP
SYSTEM SETUP
CHEMLINK
VA SPEED PUMP
ONETOUCH
LABEL AUX
FREEZE PROTECT
AIR TEMP
SEASONAL ADJ
DEGREES C/F
MORE
MENU
HELP
PROGRAM
SET TEMP
SET TIME
DISPLAY LIGHT
LOCKOUTS
PASSWORD
PROGRAM GROUP
SYSTEM SETUP
CHEMLINK 1
ORP 650
PH 7.5 OK
ORP SETUP
PH SETUP
ORP MANUAL FEED
PH MANUAL FEED
LEVEL SWITCH