Peltor PowerCom Plus MT53H7A4610 Instrucciones De Uso página 8

Operating Instructions.........
PowerCom Plus, PowerCom and LiteCom all operate on the same simple 3 key touch pad configuration
(#8 fig H) and 1 PTT button.
1. On/Off/Mode Selection (O)
This button will turn the headset on or off by holding it down for more than 2 seconds. Once the
headset is turned on, it reverts to a mode menu selection button, see below for mode menu details.
Step-by-step mode menu selection
Simply press the (O) key and the headset will confirm via a voice message what mode menu has been
selected. Every time the (O) key is pressed it continues onto the next mode menu item followed by a voice
confirmation. Once in the mode of choice, refer to instructions below on the (+) and (-) keys.
Quick step mode menu selection
By pushing (0) key several times in a row, it will quickly scroll down the modes the equivalent number of
times the (0) was pushed, followed by a voice confirmation of the menu item selected.
The headset will revert back to Surround Volume Mode (in PowerCom Plus headsets) and Radio Volume
mode (in PowerCom and LiteCom headsets) if the (0) or (+) (-) keys are not activated within 5 seconds
while making selections.
reverted.
2. UP (+) Increases the steps within the mode selected, followed by a voice
confirmation of step selected.
3. DOWN (–) Decreases the steps within the mode selected, followed by a voice
confirmation of step selected.
4. PTT
Located on the backside of the right ear cup. The thumb activated push-to-talk button
will key up the lip microphone and activate the radio inside the headset to start
transmitting.
Operating Details...
Turn the unit on by pressing the (O) key for more than 2 seconds and promptly let go, the headset will
emit a raising series of 3 tones confirming the headset is turned on. To turn the unit off, again hold
the (0) button for 2 seconds and promptly let go, the headset will emit a decending series of 3 tones
confirming the headset is off.
Once the headset is on and ready to be used, the (0) key becomes the mode menu selection button:
Mode Menu Selections
SURROUND
Applicable for PowerCom Plus headset models only.
This mode adjusts the volume level of the cup microphones (#10 fig H). Pressing the (+) (-) keys while in
this mode will either increase or decrease the surrounding ambient noise level being reproduced inside
the headset. A voice message confirms each new setting as the (+) (-) keys are pressed. There are 5
volume levels and an off level. Off can be activated by scrolling down to level 1 then hold the (-) key down
for 1 second and release, a voice message confirmation will follow saying "surround off". To reactivate
push the (+) key once and the mode will revert back to the level 1 surround volume setting.
6
A beep will be heard in the headset indicating mode has automatically