Operating Instructions; Ac/Dc Voltage; General Instructions; Measurement Operation - koban KMD 04 Manual De Instrucciones

KMD 04
Digital multimeter

Operating instructions

General Instructions

Data Hold
Press HOLD to keep the current reading on the display. To release the hold,
press HOLD again or switch functions on the rotary swtch to return to normal
readings.
Manual/Auto Range
• The meter's defaultr range is auto-range. The meter will automatically pick
the appropriate range for measurement.
• In manual range, the rangeis specified by the user, locking the display into
one specific range.
To enter manual range:
1. Press the RANGE button. AUTO will disappear from the display. Each press
of the button will increase the range and return to the lowest range once
pressed at the highest range.
Note: if you press RANGE while in data hold mode, the meter will release
the hold.
2. To return to auto-range mode, hold RANGE until AUTO appears on the
display.
Auto Power off
After 20 minutes of non-use the meter will turn itself off. Press HOLD or turn
the rotary switch to any position to turn the meter back on.

Measurement Operation

DC/AC Voltage
Warning
To prevent personal injury or damage to the meter, do not measure
voltages that might exceed 600V DC/AC rms.
DC voltage ranges: 400.0mV, 4.000V, 40.00V, 400.0V, 600V. AC voltage ranges:
400.0mV, 4.000V, 40.00V, 400.0V, 600V (400.0mV range only available in
manual range).
Instructions manual | 28 www.grupotemper.com