Safety Symbols - koban KMD 04 Manual De Instrucciones

• Do not perform a voltage test using the 10A input jack.
• Always be careful when working with voltages above 60V DC or 30V
AC rms. Keep fingers behind the probe barriers when making voltage
measurements.
• Never exceed the protection limit values indicated in the specifications for
each range of measurement.
• Choose the highest range when the value to be measured is unknown
beforehand.
• Whe connecting the test leads to a measurement circuit, connect the
common lead first, the the live lead. Reverse when disconnecting.
• Disconnect leads from circuit before switching functions/ranges.
• In order to avoid incorrect DC voltage readings, check the circuit for AC
voltage first, then put the meter in the appropriate DC voltage range.
• Turn off the power to circuit and discharge all capacitors before making
resistance, continuity or diode measurements.
• Disconnect leads from circuit before testing transistors.
• before making current measurements, turn off power to the circuit, break
the circuit, connect the leads in series across the break, the turn the power
back on for measurement.
• When the symbol appears, replace the batteries to avoid incorrect
readings.

Safety Symbols

Caution: refer to the instruction manual. Incorrect use may
result in damage to the device or its components.
AC (Alternating Current)
DC (Direct Current)
AC or DC
Conforms to European Union directives
Earth ground
Double insulated
Fuse
www.grupotemper.com
KMD 04
Digital multimeter
Instructions manual | 23