Powering The Xpo - Invacare XPO2 Manual Del Operador

SECTION 6—OPERATING INSTRUCTIONS

Powering the XPO

NOTE: Both the internal and supplemental battery require full
charging prior to first use. Refer to Charging the Batteries on
page 22.
NOTE: For this procedure, refer to FIGURE 6.7 on page 29.
1. The XPO allows the freedom to choose from the following
2
power sources:
• The internal battery. The XPO
an internal battery that is installed at the factory and is
not user serviceable.
• The supplemental battery pack. To use, connect the
supplemental battery pack to the XPO
Detail "A".
• A DC power outlet (i.e. an automobile). To use, connect
the DC power adapter to the XPO
"B". Connect the other end of the DC power adapter to
the DC power source.
• An AC outlet (i.e. wall outlet of your home). To use,
connect the AC power adapter to the XPO
Detail "C". Connect the other end of the AC power
adapter to the AC power outlet.
2. If the XPO
supply is necessary, perform the following:
A. Turn off the XPO
B. Connect the external power supply (e.g. supplemental
battery pack, DC mobile power adapter, or AC power
adapter) to the XPO
C. Turn the XPO
Invacare XPO2™
is in use and connection to an external power
2
.
2
2
on.
2
2
comes equipped with
2
2
.
28
as shown in
2
as shown in Detail
as shown in
2
Part No 1160887