Publicidad
4
Position door.
4a Tape ⅛" shims to top edge of door at each corner for spacers.
4b Position door against stops and leave it resting on threshold,
with a thin pry bar placed underneath. Shift door so lockside
edge is wedged snugly against frame, top to bottom.
If necessary, use shims between the door and hinge side of frame
L
to keep door wedged safely in position.
For double doors, mark exact middle of frame header, and push
the two doors together at their meeting edges with the top corners
directly under the mark. Wedge hinge sides as above.
5
Mark hinge height and offset.
5a Refer to drawings below to mark hinge height (A) and offset (B) on face of frame.
Through bolt application shown.
For Maximum Net Opening
1⁵⁄₈"
(41 mm)
B
For Minimum Frame Width
Allow ¹⁄₈" for cover
⁷⁄₈"
(22 mm)
B
2
157XY
¹⁄₈" Gap
A
For 157XY, offset aligns
!
with edge of frame leaf
1³⁄₄"
(44 mm)
2¹⁄₄"
(57 mm)
OR
(76 mm)
(3.2 mm)
wedges
Single Door
B
¹⁵⁄₃₂"
1³⁄₄"
(44 mm)
3"
¹⁄₈"
shims
pry bar
For 210XY, offset aligns
!
with screw holes
¹³⁄₁₆"
(21 mm)
B
Model 210XY requires
!
re-templating of existing
overhead closers to
match the pivot point of
the hinge.
If the existing closer is
not re-templated, the
door will open to 70
degrees in a 90 degree
¹⁵⁄₃₂"
opening.
Double Door
210XY
¹⁄₈" Gap
B
A
Publicidad
