Publicidad
x4
Do not tighten.
!
Screws must be
7f
Install screws into two or three round holes at both top and bottom of hinge. Open and close door slowly, checking all edges
free enough to slide
for clearance. Repeat for double doors.
in slots when
For through bolt applications only, skip ahead to steps 7h - 7k.
door is raised.
L
If lock side clearance is satisfactory, insert remaining screws into round holes.
x6
Do not tighten. These
!
screws will locate and
maintain door height.
7g Tighten all screws on door leaf. Reconnect the closer and any other hardware.
For through bolt applications only
7h When door is aligned, mark all locations for through bolts in round holes on hinge. Eight through bolts are provided and it is
recommended to install at least one on each end of hinge if choosing to use through bolt installation option.
7i
With the hinge still mounted to the frame, remove the door from the opening and drill the through bolt holes all the way
through the door with 9/32" drill bit.
For the remaining round holes, TEK screws will be used. A #16 bit is recommended to drill pilot holes.
L
DO NOT DRILL TEK SCREW HOLES THROUGH THE DOOR.
L
7j
On the push side of door only, enlarge the through bolt holes using a 13/32" bit. For wood or composite doors, only drill the
through bolt holes 1-1/2" deep.
7k Secure door to hinge with 1/4"-20 screws and through bolts. Install TEK screws in pilot holes and tighten evenly.
⁹⁄₃₂" drill
Enlarge to ¹³⁄₃₂" on push side (x 1¹⁄₂" deep for wood)
Through bolts applicable only for doors up to 2¹⁄₄"
!
thick.
7l
Reconnect the closer and any other hardware.
x6
Do not tighten. These
!
screws will locate and
maintain door height.
Non-through bolt
application shown
Through bolt
TEK screw
#16 pilot drill
recommended
5
Publicidad
