Publicidad
6
Mount hinge to frame.
6a Open hinge and place frame leaf flat against face of frame.
For 157XY, the narrower leaf is the frame leaf.
L
6b Align hinge to height and offset marked in previous step. Top of hinge should be ⅛" below underside of frame header.
6c Mark frame through center of topmost hole using the transfer punch provided. Drill pilot hole, then hang hinge from the
frame leaf.
For 157XY, use one of the hex head screws and a ⁵⁄16" (8 mm) hex socket driver.
L
For 210XY, use a flat head screw.
6d Plumb the hinge with a level and mark the hinge position at the bottom of the frame.
6e Use a transfer punch as before to set another screw near the bottom of the frame leaf.
6f Install the remaining screws in the frame leaf. Repeat sequence for double doors. Tighten all screws before proceeding.
If door is located so close to an inside corner that it can only be opened 90°, refer to Step 8 and install the frame leaf cover at this
L
time. Confirm you are satisfied with the frame leaf attachment before installing this cover. Covers are non-removable.
157XY
#16 pilot drill
recommended
210XY
#16 pilot drill
recommended
3
Publicidad
