Publicidad
7
Mount door to hinge.
7a Fold door leaf of hinge against door. Install a hex screw at
(210XY)
the bottom end of each vertical slot.
(210XY)
(157XY shown)
(157XY shown)
(157XY shown)
7b Use pry bar to raise door until tight against shims between
the top of door and frame header.
4
#16 pilot drill
recommended
For wood doors, use ⁷⁄₁₆" hex ¹⁄₄"
!
x 1¹⁄₂" lag screws from optional
wood door mounting package.
#16 pilot drill
#16 pilot drill
recommended
recommended
x4
Do not tighten.
!
x4
x4
Screws must be
free enough to slide
Do not tighten.
in slots when
!
Do not tighten.
!
Screws must be
door is raised.
Screws must be
free enough to slide
free enough to slide
in slots when
in slots when
door is raised.
door is raised.
x6
⁹⁄₃₂" drill
!
Thru bolts
x6
(210XY)
Do not tighten. These
!
applicable only
x6
screws will locate and
for doors up to
maintain door height.
2¹⁄₄" thick.
Do not tighten. These
!
Do not tighten. These
!
screws will locate and
screws will locate and
maintain door height.
maintain door height.
(157XY shown)
(210XY)
!
For wood doors, use ⁷⁄₁₆"
!
For wood doors, use ⁷⁄₁₆"
hex ¹⁄₄" x 1¹⁄₂" lag screws.
hex ¹⁄₄" x 1¹⁄₂" lag screws.
(157XY shown)
7c Install screws into lock side end of each horizontal slot.
Repeat for double doors.
7d Remove shims from top of door(s) and remove screws
from vertical slots.
#16 pilot drill
recommended
x4
7e Adjust lateral clearances of door by prying door from lock
side of frame. For double doors, make sure they remain
Do not tighten.
!
centered.
Screws must be
free enough to slide
in slots when
door is raised.
x6
Do not tighten. These
!
screws will locate and
maintain door height.
⁹⁄₃₂" drill
⁹⁄₃₂" drill
⁹⁄₃₂" drill
(210XY)
(157XY shown)
!
For wood doors, use ⁷⁄₁₆"
hex ¹⁄₄" x 1¹⁄₂" lag screws.
!
Through bolts
applicable only
x4
for doors up to
2¹⁄₄" thick.
Do not tighten.
!
!
Screws must be
!
Thru bolts
free enough to slide
Thru bolts
applicable only
in slots when
applicable only
for doors up to
door is raised.
for doors up to
2¹⁄₄" thick.
2¹⁄₄" thick.
#16 pilot drill
recommended
x6
Do not tighten. These
!
screws will locate and
maintain door height.
x4
Do not tighten.
!
Screws must be
⁹⁄₃₂" drill
free enough to sl
in slots when
door is raised.
x6
Do not tighten. Th
!
screws will locate
maintain door hei
!
Fo
he
Publicidad
