KTM 69034081044 Manual Del Usuario página 11

1
2
4
- Remove original screw (1).
- Position the retaining plate for ON/OFF switch (2) and mount it with
screw M6x20 (1) included in the scope of supply.
- Mount the ON/OFF switch on the retaining plate and plug the connector
of Cable1 into the switch (Figure A).
NOTE:
After assembly, check all cables to ensure that the connectors are properly
positioned on the switch.
Requirement for ignition on:
When the switch is set to 1, the sensor box LED must be green.
If not, swap the connectors.
A
- Connect Cable2 to the quick shifter.
- Route Cable2 forward.
- Pull off the original connector of the stick coil (3) behind the air filter
box.
3 - Plug the connector of Cable2 into the stick coil and connect the original
connector with the other connector of Cable2.
- Route Cable2 forward further.
- Remove filter box cover (4) to gain access to the front stick coil.
- Make the plug-in connections as done previously for the stick coil.
Connect the cable of the sensor box to the quick shifter.
Properly route all cables and secure them with cable ties.
Ensure that the cables are neither kinked nor pinched.
11