Publicidad
Step 12
Carefully turn your unit over onto its front edges. Lay the LARGE
å
BACK (F) over your unit.
Turn six BLACK 9/16" LARGE HEAD SCREWS (1S) into the bottom
å
edge of the LARGE BACK (F) and into the BACK (E). Do not
completely tighten the SCREWS at this time.
Then, making sure that the top edge of the LARGE BACK (F) sits
å
slightly below the top edge of your unit, fasten the top and side edges
of the LARGE BACK to your unit using the NAILS (1N).
Now, completely tighten the SCREWS in the bottom edge of the
å
LARGE BACK (F).
NOTE: A perforation has been provided for access through the
å
LARGE BACK.
Using your hammer, gently tap four TACK GLIDES (12E) into the
å
bottom edges of the LEGS (G, H, and I).
BLACK 9/16" LARGE HEAD SCREW
(6 used in this step)
G
12E
Page 16
1S
I
E
420566
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(16 used in this step)
The perforation
should be here.
F
I
H
1N
NAIL
www.sauder.com/service
Publicidad
