Sauder 420566 Manual De Instrucciones página 9

Step 5
Lay the ENDS (A and B) fl at on the fl oor exactly as shown.
å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the
å
ENDS (A and B) until the shoulders of the SCREWS rest on the
surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (L) onto the ENDS (A and B). Line up
å
the grooves in the MOLDINGS over the heads of the SCREWS in
the ENDS.
NOTE: If the MOLDING comes up off of the SCREWS, remove it
å
and slide it on again.
RIGHT END ASSEMBLY
These edges
should be even.
LEFT END ASSEMBLY
These edges
should be even.
www.sauder.com/service
L
32S
B
L
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
A
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
420566
32S
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Shoulder
Shoulder
Page 9