Installation Instructions - Sauder 420566 Manual De Instrucciones

Step 16
Carefully stand your unit upright in its fi nal location. We recommend using the SAFETY STRAP for added stability.
å
Open the FURNITURE TIPPING RESTRAINT KIT (97).
å
NOTE: Do not turn the SAFETY DRYWALL ANCHOR into a wall stud. If you prefer to fasten the SAFETY STRAP to a wall
å
stud, go to your local hardware store for proper hardware.

INSTALLATION INSTRUCTIONS:

å
1. Insert the SAFETY DRYWALL ANCHOR through the WASHER and one end of the SAFETY STRAP.
2. Using a Phillips screwdriver or a hand drill, press the screw slightly onto the drywall.
3. Apply pressure; turn the screw until a pilot hole is made and the nylon sheath slips through.
4. Turn the screw until it is fl ush against the wall and you feel a fi rm resistance.
5. Continue to turn until the screw starts spinning freely.
Carefully cut out the perforated hole in the LARGE BACK (F). Insert the other end of the SAFETY STRAP through this hole,
å
then use a BLACK 9/16" LARGE HEAD SCREW through the SAFETY STRAP and into the pre-drilled hole in the underside
of the TOP.
NOTE: Before moving your unit to a diff erent location, unscrew the SAFETY DRYWALL ANCHOR from your wall. The
å
nylon sheath will remain behind your wall.
Page 20
F
420566
Washer
Safety strap
BLACK 9/16" LARGE HEAD SCREW
(1 used in this step)
97
www.sauder.com/service
Safety
drywall
anchor