Suzuki DL1000AL4 Instrucciones Para El Montaje página 4

4/15
2. Slide the boot and remove the
throttle case bolts from the
throttle case. Disconnect throt-
tle cables carefully from the
right grip. Pull out the right grip
from the handlebars.
NOTE: Removed right side grip
3. Pass the Grip Heater (R) D
lead wire to front of the handle-
bars.
4. Install the Grip Heater (R) D in
the order of removal.
• Apply thinly grease to the
• Apply grease to the end of the
 99000-25011:
• Connect throttle cables to the
GENUINE SUZUKI ACCESSORIES
will not be reused.
handlebars.
throttle cables and cable pul-
ley.
SUZUKI SUPER GREASE
"A" or equivalent
throttle cable pulley of Grip
Heater (R) D.
Boot Boot
Throttle case bolt Throttle case bolt
Throttle cable No.1 Throttle cable No.1
Grip Heater (R) Grip Heater (R)
Throttle cable No.2 Throttle cable No.2