Suzuki DL1000AL4 Instrucciones Para El Montaje página 7

5. Before cement is dried, spray
the degreasing detergent to the
inside of the Grip Heater (L) E
and to the handlebars, then,
insert the grip. Slide Grip
Heater (L) E onto handlebars
with the lead wire pointing
down.
NOTE: Perform installation quickly,
before the cement dries.
NOTICE
Hitting the grip end with a
hammer or twisting the grip
can damage the grip heater
due to heater wire cut.
• Do not hit the grip end with a
hammer or twist it forcibly.
• When the grip cannot be
inserted in midway, pull out
the grip by pouring the
degreasing detergent into a
gap between the grip heater
and the handlebar. At this
time, do not twist forcibly
the heater wire with a screw-
driver or such similar tool.
Grip Heater (L)
FRONT
Lead Wire
GENUINE SUZUKI ACCESSORIES
7/15
Grip Heater (L)
Handlebar
UP
Grip Heater (L)